~~This is an advanced Mod. It requires Dismantling, Unsoldering, Soldering, microsoldering, MidwestGadgets and its partners cannot be held responsible for your device if you attempt this mod. Even successful install, if due to a bridge or incorrect joints this modification damages your M1, MidwestGadgetsLLC is not liable. You void any Monstatek Warranty performing this modification.~~

TLDR: If you Break your M1 its on you.  And the Odds are High you will Break it.
 
Current Screen is white. This is (almost)White, Red, Blue, Green and all the colors in between.
 
Theres a pad on the back labeled "Run to Vibro". this is a mistake i made when designing it. I designed the layout before i had the M1 in hand and i mimicked the Flipper board and i wrongly assumed we would connect that pad to Vibro on the M1. The M1 doesnt have a vibrate feature. So No Vibro.
 
Instead as of writing this we connect the Data Pad to PD3. This is a very tiny pad to the right of the STM Chip and to the upper left of the LCD Ribbon Cable Connector. It is tiny. It is also right next to the pins of the STM and the Ground pin for the ribbon connector. You risk shorting out your entire M1 connecting this data line so please be careful.
 
The Current Stock firmware does not support RGB. However the amazing tip-toeing Genius that he is @Dagnasty has created excellent firmware for this particular mod.
 
Check out his fork here
 
 
 
Video and supporting installation Pictures forthcoming.